h1

Paint Test on Tyvek Synthetic Fabric

June 11, 2018

Following up on the Tyvek fabric that I showed in my previous post, I wanted to show some paint tests on it using both oils and acrylic paints. In the photo above I painted a few sample swatches of each using different tools and methods. As a reminder, this is a 9×12 inch sheet of polyethylene fabric, “Tyvek” brand, mounted to mat board with acrylic gel.

For the oil paint on the left I used stiff a hog brush and soft sable, as well as a paint knife. Some areas were thinned with mineral spirits, or wiped down with a soaked rag. All of this worked out fine. There were a couple problems to point out, however. In the center yellow area, I used a stiff brush soaked with spirits, and scrubbed the surface hard. This caused the fabric to come unglued from the backing in that area (see the image below.) The other problem happened scraping lines with a metal paint knife. When I applied a lot of pressure it caused the thin fabric to tear. Although it is tear resistant, it’s not tear proof when using a metal tool. Otherwise, it works very well with oils. Since this surface is slightly porous, if your backing is a paper product I recommend sizing it properly if you will be using oil paint on this.


.
.
In the acrylic paint section everything worked well with the range of tools I tested. This included the same type of brushes as used with the oil, a paint knife, a rag, and also acrylic paint markers (DecoColor & Molotow.)

Above are a couple things to point out about using acrylic paint. With a metal paint knife I was able to scratch through the paint surface rather easily after the paint had dried. It’s an interesting effect, but also shows that the adhesion is not perfect, but acceptable. This layer (left image above) of burnt umber was painted with a stiff brush in the top area, and again below it with water added. You can see how the water beaded up as it dried. When using a wet soft sable brush, this was less noticeable. The paint also takes a little longer to dry on this surface than it does on regular paper. After a minute or so I was able to wipe it off almost completely with a damp rag. In these closeups you can also see a small square grid pattern showing through from the fabric where the paint is thin. The square is only about 1 mm. It’s less noticeable in areas where the paint is more opaque.

Keeping these points in mind, I would still have no problem using this as a paint surface for oils or acrylics. Being synthetic, it wouldn’t have some of the aging or humidity problems that come with natural fiber canvas. It’s also very inexpensive, and comes in large size rolls. I may do another test using water-based paints of gouache and casein, as well as different drawing media, so stay tuned.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

w

Connecting to %s

This site uses Akismet to reduce spam. Learn how your comment data is processed.

%d bloggers like this: