h1

Table Saw Jig for 45 Degree Mitre

February 5, 2017

I used a few pieces of scrap wood today to make a simple table saw jig to cut 45 degree angles for mitred corners. My push guide was not all that accurate, so this will help me cut better fitting corners for frames.

45degree_tablesaw-jig2

It’s made of two pieces of 1 x 2″ strips screwed together at 90 degree angles with the their ends cut at 45 degrees. I added to smaller strips of wood to the edges: one long one in the front to support tall wood pieces that might be cut, and a small strip to attach the jig to the push guide. The guide has two grooves in it for blots to attach the jig, but I didn’t have the right size bolts handy. In the meantime I can just use a clamp.

Still to do: If I add a piece of wood extension to the back of the jig where the push guide is, I can attach a wood strip on the bottom that fits into the table groove so I won’t have to use the push guide at all.

Advertisements

One comment

  1. […] Artwork and Musings of David Blaine Clemons « Table Saw Jig for 45 Degree Mitre […]



Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: