Homemade Table Easel version 3

September 12, 2016

Being between projects I decided I would take the time to make modifications to my last table top easel design.


The vertical arms are a little taller, and I added a sliding rail at the bottom so they can move forward slightly. There’s a front lip at the bottom that can slide forward about 3 inches to adjust the angle of the artwork from near vertical to about 30 degrees. Something new is a center brace that I can use for small pieces to sit higher up, and support taller artwork. The bottom is about 14 inches square, and the center brace goes up about 20 inches.


One comment

  1. I should have written 50 degrees on the tilt angle, not 30.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )


Connecting to %s

This site uses Akismet to reduce spam. Learn how your comment data is processed.

%d bloggers like this: